CISCO SPEED METER PRO ACTIVATION KEY FULL

You can choose Static, Dynamic, or Active-backup.įor information about link aggregation modes, see About Link Aggregation. From the Mode drop-down list, select the link aggregation mode to use.(Optional) In the Description text box, type a description for the link aggregation configuration.In the Name text box, type a name for this link aggregation configuration.The Link Aggregation settings page appears. To configure a new link aggregation interface, click Add.

Use the previous procedure to set the interface type to Link Aggregation.

To configure an interface as an available link aggregation member, click Configure.The interfaces configured as type Link Aggregation are listed at the top. You can then create the link aggregation interface and add these interfaces as the link aggregation members. To configure link aggregation in Fireware Web UI, you must first configure one or more physical interfaces and select Link Aggregation as the interface type. Configure Link Aggregation in Fireware Web UI

CISCO SPEED METER PRO ACTIVATION KEY FULL

If you use eth8 or eth9 as a member of a link aggregation interface on these models, you must set the Link Speed to 10000 Mbps, full duplex (10 Gbps full duplex) in the link aggregation interface configuration and on the connected network switches. For Firebox M590 and M690 models, interfaces 8 and 9 support only 10 Gbps full duplex (FD). Physical interfaces that are members of a link aggregation interface must support the same link speed. Each link aggregation interface can have one or more physical interface members.īefore you configure link aggregation, review the requirements and limitations in About Link Aggregation. A link aggregation (LA) interface is a group of physical interfaces that you configure to work together as a single logical interface.

Cisco speed meter pro activation key